What are the best screws to use for plywood boat building and can i use planks for a flat bottom with epoxy.? - plywood boat templates
I will use plywood for the sides and a model for how could I use masonite or hardboard.Also I add seats in the ribs and the ribs or a visa versa.I used epoxy and then I would sand the aluminum oxide, several layers of marine colors or less oil sandpaper.Then paint.Any basic ideas are welcome, especially on the screws.
Monday, January 25, 2010
Plywood Boat Templates What Are The Best Screws To Use For Plywood Boat Building And Can I Use Planks For A Flat Bottom With Epoxy.?
7 comments:
Brass screws commonly used in marine applications for many years. Stainless steel can, but I rather bronze. I have personal experience in this situation and have built several small boats hull of plywood. Brass has always served us well, and I am building a new boat, I brass screws. The marine epoxy paint would be my choice in the image of a ship. I do not think I'll tables for the use of this fund. I built boats Joh table, but there are problems. Basically, they tend to flee. While they are in the water and self-absorbed, the plates will swell and seal against each other, but should still be moist all the time. When they dry, shrink and leaking badly. If the color and stamp of the table, where everything is "watertight" before installing, it is almost impossible for your partner enough to neighboring tables seal completely. Very unsatisfactory. I would be marine plywood instead of tables. I think it will be happier with the result. I know there are books availbe Shipbuildingvaluable information for you would be considered. I think it would be a thorough investigation before deciding whether to make an end of the table! Hope this helps! DP
Nothing galvanized with a little oil before the screws in zinc are not removed when you are screws sink and prevent a little glue on the back so that the maximum oxide usage. like the painting down
Use of stainless steel. This is not the cheapest, but 10 happy years.
Thebest brass screws, but the stainless steel d. You can use epoxy on the bottom. West System ID well. Avoid Masonite around water, but as a model.
Thebest brass screws, but the stainless steel d. You can use epoxy on the bottom. West System ID well. Avoid Masonite around water, but as a model.
Thebest brass screws, but the stainless steel d. You can use epoxy on the bottom. West System ID well. Avoid Masonite around water, but as a model.
I am sure, others respond, but I think the deck of the Treaty. They seem to be very good in these applications. What happens with a polyurethane finish? I think a boat that had the appearance of natural wood is very nice. They do not know whether to use navy or not? "
Just a few ideas
Post a Comment